Non-locking cap with optional chain
Locking cap with optional ‘Diesel’ labels
‘Customised’ Key option
Optional ‘Snap-in’ Barrel ‘FS’ or ‘FT’
Ordering Code
| ‘Non-vented’ models with 68 mm bayonet | |
| 602935 | ‘Chunky’ cap locking, black |
| 602936 | ‘Chunky’ cap, non-locking, black |
| ‘Vented’ models with 68 mm bayonet | |
| 600281 | ‘Chunky’ cap, locking, black |
| 600296 | ‘Chunky’ cap, non-locking, grey |
| 616900 | Steel neck-end, 77 mm diameter |
| 616901 | Steel neck-end, 58 mm diameter |
Ask for advice on suitability of caps where venting is required. EC regulations may apply.
Specification
| A | Diameter | 87 mm |
| B | Base height | 24 mm |
| C | Max. height | 42 mm |
| D | Inside diameter | 84 mm |
| E | ‘Bayonet’ diameter (not shown) | 68 mm |
Note: Alternative ‘bayonets’ can be fitted at 45mm & 55mm diameter, but these will reduce resistance of cap to vandal attack.
- Attractive, moulded ‘shroud’ with textured finish, and shaped top for good grip. ‘Snap-in’ lock barrel allows cap to be matched with full vehicle lockset.
- Rotate cap on filler neck until fully engaged. On locking models, turn key to operate latching tongue. Key only withdraws in ‘locked’ position.
- Textured finish in black.
- Zinc alloy diecastings, with mineral-filled polypropylene shroud, steel ‘bayonet’ & latch, and bonded steel/nitrile rubber seal.
-
- Valved/vented specification
- ‘Bayonets’ at 45 & 55 mm
- Optional retaining chain
- ‘Diesel’ labels
- ‘Snap-in’ barrel
- ‘Customised’ key types. - Caps are 100% tested to withstand tank pressure of 0.14 KgF/cm2 (2 lb/in2) Inversion tests ensure caps do not exceed permitted flow rates on valved/vented models.
